background image

14

H. LP gas pressure low at burner.

Set main regulator so pressure does not drop

below 11 inches of water column at pressure test

port. (See FIG. 12).

I. Burner not located properly under flue tube.

Relocate.

J. Burner damaged.

Replace.

K. Odor from fumes.

1. Dislocated burner

2. Damaged burner

3. Dirty flue tube

L. FUSES

1. Refrigerator AC Supply
2. Refrigerator DC supply
3. Refrigerator control system
See page 12, part FUSES.

NOTE:  AVOID  SPRAYING  WATER  THROUGH  THE

REFRIGERATOR VENTS WHILE WASHING YOUR RV.

All the above instructions are to be followed closely. The

refrigerator is quality-guaranteed. However, we are not

responsible for any failures caused by improper adjust-

ments and unfavorable installation conditions. Contact

service point or distributor service dept. for assistance.

CHANGING DOOR HINGES FROM ONE

SIDE TO THE OTHER

The refrigerator is equipped with convertible doors. To

change the door swing, consult the parts manual for the

Conversion Kit Number. For further information, please

contact Dometic Corporation listed on the front page.

INSTRUCTIONS FOR MOUNTING

THE DOOR PANEL

The refrigerator is normally delivered without door panels.

Before starting the mounting work, check that the panel

dimensions are in compliance with those given in the

table and the instructions are read thoroughly.

When mounting the panel, proceed as follows:

See figure page 15.

A. Open the door 90 degrees.

On new refrigerators, the decoration strips are

taped inside the door; if installed on the door,

remove the door decoration strip (2) by removing

its three screws (1).

B. Insert the vertical edges into the grooves of the

door frame (3).

C. Push the panel downward so that the lower hori-

zontal edge of the panel (4) is fitted into the bottom

grove (5).

D. Put the decoration strip across the door so that the

gap is covered. Secure the decoration strip with the

three screws removed in Step A (1).

SPARE PARTS

The following list is a list of commonly used parts, which

should be available, if required, from your Dometic Ser-

vice Center.

A = RM 3662;  B = RM 3663;

C = RM 3862;  D = RM 3863.

Part No.

Description

200 74 19-21/7 A B C D Jet, No. 58

293 06 97-07/9 A B C D Burner, with conductor

293 27 81-01/2 A B C D Electrode

293 26 67-03/9 A B - - Baffle

293 26 67-04/7 - - C D Baffle

293 11 32-01/9 A B C D Spark ignition device

  17 37 68-03/7 A B C D Heater, 325W, 115V

  17 37 57-08/9 - B - D Heater, 215W, 12V

293 20 52-01/8 A B C D Thermocouple

293 25 76-02/4 A B - - Door shelf, 2 pieces

293 25 76-02/4 - - C D Door shelf, 3 pieces

293 25 75-02/6 A B C D Door shelf, lower

293 26 21-02/8 A B C D Box vegetable-

293 21 06-01/2 A B C D Lamp cover

293 20 93-01/2 A B C D Handle (light brown)

293 20 93-03/8 A B C D Handle (black)

293 27 50-08/2 A B C D Door reversing kit,

right-left (light brown)

293 27 50-09/0 A B C D Door reversing kit,

left-right (light brown)

293 27 50-11/6 A B C D Door reversing kit,

right-left (black)

293 27 50-12/4 A B C D Door reversing kit,

left-right (black)

Contact an authorized service center for

parts and repairs as needed.

PANEL DIMENSIONS

MAX. THICKNESS 5/32" (4 mm)

REFR. MODELS

HEIGHT

WIDTH

TYPE

MAX.

MIN.

MAX.

MIN.

RM 3662 RM 3663

upper

mm

403

401

527

524

inch

15-27/32

15-25/32

20-3/4

20-5/8

lower

mm

827

825

527

524

inch

32-9/16

32-1/2

20-3/4

20-5/8

RM 3862 RM 3863

upper

mm

403

401

527

524

inch

15-27/32

15-25/32

20-3/4

20-5/8

lower

mm

983

981

527

524

inch

38-11/16

38-5/8

20-3/4

20-5/8

All manuals and user guides at all-guides.com

Summary of Contents for RM3662





















Reviews: