Dometic RM663 and, Installation And Operating Instructions Manual

SPECIAL HINTS
The 

refrigerator must be installed in a substantial enclosure and

must be level. A spirit level is supplied with each refrigerator and
by placing it in the freezer compartment one can level the
refrigerator both ways front to back and side to side. When instal-
ling the refrigerator in the enclosure care should be taken to
ensure a complete sealing between the front frame of the
refrigerator and the top, sides and bottom of the enclosure. For

this purpose a length of sealing strip is applied to rear surfaces of
the front frame.
Any space between counter or storage area and the top of the
refrigerator greater than 1 1/2" should be blocked. The heat pro-
duced at the rear of the refrigerator will otherwise become trap-
ped in this space making the top of the refrigerator hot and

reducing the efficiency of the refrigerator.

TO CHANGE THE DOOR OPENING FROM

LEFT TO RIGHT OR VICE VERSA

Open the 

door and unscrew the two screws holding the top front

cover. The screws are accessible from beneath. Remove the top
hinge pin and lift out the door.
The lower pin for the refrigerator door should be shifted to the
opposite side.
The door can then be remounted. Before the top front cover is
refitted check that the door closes easily and that the gasket
seals well on all sides.

TO REMOVE AND REPLACE
THE REFRIGERATOR

Before working on the refrigerator make sure that 120  V A.C. and

optional 12 V D.C. leads are disconnected.
Unscrew the hexagon nut 11 and the bracket which holds gas
shut-off valve 8, see fig. 1 pos. 8. Let the gas valve remain on the
gas line.

Loosen the screws fixing the refrigerator to the enclosure and
remove the refrigerator. See fig. 9.

When replacing the refrigerator make sure that the sealing strips
are properly positioned. After reassembly the gas connection

Fig. 8

should be checked for leaks.

Fig. 9

WIRING DIAGRAMS

VEH. BATTERY

Motor Home

Tow Vehicle

Travel Trailer