EN
Troubleshooting
RMD10.5XS
28
7.1
Fault messages and signal tones
All faults are indicated by a warning symbol, a fault ID and a beep. The beeping lasts
for 2 minutes and is repeated every 30 minutes until the error has been rectified.
If multiple faults occur, the display shows the last fault. The underlying faults are dis-
played after the last fault has been rectified.
In the event of a fault, the LED warning symbol (
)
in the display lights up continu-
ously and the LEDs flash according to the fault.
The refrigerator is not
cooling adequately.
The ventilation around the
cooling unit is not sufficient.
Check that the ventilation grill is not
obstructed.
The evaporator is iced up.
Check whether the refrigerator door
closes properly.
Make sure that the refrigerator seal fits
correctly and is not damaged.
Defrost the refrigerator.
The temperature is set too high.
Set a lower temperature.
The ambient temperature is too
high.
Remove the ventilation grill for a while
so that warm air can escape quicker.
Too much food was placed in the
refrigerator at once.
Remove one or more items of food.
Too much warm food was placed
in the refrigerator at once.
Remove the warm food and leave it to
cool down before putting it in again.
The refrigerator has not been
operating long enough.
Check the temperature again after four
or five hours.
Fault
Possible cause
Suggested remedy
DometicRMD10_OPM_4445103187_APAC(en)_202x_xx-xx.book Seite 28 Donnerstag, 22. Oktober 2020 1:03 13