EN
Safety instructions
RMDT10.5(X)T
18
!
CAUTION! Failure to obey these cautions could result in minor or
moderate injury.
Electrical shock
•
Before starting the device, ensure that the power supply line and the
plug are dry.
Risk of crushing
•
Do not put your fingers into the hinge.
A
NOTICE! Damage hazard
•
Only hold the device at the body of the device during transport. Never
hold the device at the absorber unit, the cooling fins, the gas pipes,
the door or the control panel.
•
Make sure that the device circuit is not damaged during
transportation. The refrigerant in the device circuit is highly
flammable.
In the event of any damage to the device circuit (smell of ammonia):
–
Switch off the device if applicable.
–
Avoid naked flames and sparks.
–
Air the room well.
•
Do not install the device near naked flames or other heat sources (heat-
ers, direct sunlight, gas ovens etc.).
•
Danger of overheating!
Always ensure sufficient ventilation so that the heat generated during
operation can dissipate. Make sure that the device is sufficiently far
away from walls and other objects so that the air can circulate.
•
Check that the voltage specification on the type plate is the same as
that of the power supply.
•
Do not open the refrigerant circuit under any circumstances.
•
Only use the AC connection cable supplied to connect the device to
the AC mains.
•
Only use cables with a suitable size.
•
Never pull the plug out of the socket by the connection cable.
•
The device may not be exposed to rain.
DometicRMDT10_INM_4445103409_EMEA18_2021-xx-xx.book Seite 18 Dienstag, 25. Mai 2021 1:08 13
