EN
Installing the refrigerator
RMDX21, RMDX25
28
6.7
Securing the refrigerator
!
I
➤
Move the refrigerator into its final location.
➤
Fasten the four screws (fig.
k
1, page 8) through the four plastic
washers in the sides of the refrigerator, and further into the wall.
➤
Put the caps (fig.
k
2, page 8) onto the screw heads.
6.8
Replacing the door panel
A
Only decorative trim with frame:
The door panel has the following
dimensions (fig.
l
, page 8):
z
Freezer compartment door: A
z
Refrigerator door: B
Removing the door panel from framed door model
Proceed as follows (fig.
m
, page 9):
➤
Remove the door trim carefully. It is only clipped in and held in place by
small hooks.
➤
Pull the old panel away from the door trim still installed.
➤
Push the old panel upwards as far as the stop.
➤
Pull the old panel out of the door.
CAUTION!
Only screw through the receptacles provided, otherwise foamed
components, including cables, can be damaged.
NOTE
Attach the side walls or the attached strips so that the screws are
tight, even when under increased loads (while driving).
NOTICE! Beware of damage
The door panel must not be replaced when the refrigerator is
upright.
Summary of Contents for RMDX21
