Electrical operation
1. 12V - operation (DC)
Set energy selector switch (A) to 12 V .
The refrigerator operates without thermostatic
control (continuous operating).
2. Mains power
Gas operation
7
A
5.2.2
5.2.3
The refrigerator should only be operated using liquid gas (Propane,
Butane). Do not use Autogas, town gas or natural gas.
If the refrigerator is operated during travel using gas, the precautions
stipulated by the legislation in the respective country must be taken (in
conformity with the European standard EN 732).
Due to physical reasons, ignition faults could occur starting from an
altitude above sea level of approx. 1000 m / 3280 ft. (No malfunction!).
As a basic rule, operation using gas is prohibited in petrol stations!
All refrigerators with manual ignition are equipped with automatic
flame protection, which automatically cuts off the supply of gas
approximately 30 seconds after the flame goes out.
When using for the first time, and after changing the gas cylinder,
the gas pipes may contain air. By means of brief operation of the
refrigerator and any other gas appliances (e.g. cookers), air is
removed from the gas pipes. The gas will ignite without delay.
1. Set energy
selector switch
(A) to 230V .
2. Use rotary switch
(B) to regulate
the temperature in
the main refrige-
rator compart-
ment.
A
B
ATTENTION
The refrigerator should only be used while the motor is running.
This option should only be selected where the supply voltage of the
connection for power supply corresponds to the value specified on
the data plate. Any difference in values may result in damage the
appliance.
ATTENTION
WARNING
