EN
Installing the refrigerator
RUC8408X
16
7.3
Installing the drain water hose
➤
To avoid damage to the drain water hose, position the hole for the drain water
hose in a way that the hose does not kink.
➤
Drill a hole through the floor at the rear of the refrigerator.
➤
Install the drain water hose through the drilled hole. Ensure, that the drain water
hose is long enough in order to drain the water outside of the vehicle.
➤
Ensure that the drain water hose is not kinked.
➤
Seal the area around the drain water hose.
7.4
Installing the ventilation grille
➤
Make a cut out in the wall to fit an appropriate upper and lower vent system,
choose LS300 check the dimensions required for the vent. See chapter “Prepar-
ing the installation” on page 10.
No. in
fig.
0
Description
1
Slider
2
Ventilation grille
3
Installation frame
3
2
1
0
RUC8408X--IO-AU.book Seite 16 Freitag, 22. Dezember 2017 8:21 20