EN
Installing and connecting the refrigerator
HC 302D, HC502D
16
6
Installing and connecting the
refrigerator
6.1
Unpacking the refrigerator
1. Check that the packaging is not damaged.
2. Remove the cardboard packaging.
3. Check that the refrigerator is not damaged.
If you find damage on the packaging or at the refrigerator resulting from
transport, report it immediately to the transportation firm.
6.2
Installing freestanding version
Observe the following instructions when installing:
1. Install the refrigerator so that the warm air produced can easily flow away, either
upwards or to the sides.
2. Place the refrigerator at the chosen place.
3. Leave the refrigerator to stand for at least four hours before you connect it to the
power supply so that the refrigerant can flow back into the compressor.
6.3
Installing built-in version
!
Observe the following instructions when installing:
•
Install the refrigerator so that the warm air produced can easily flow away (either
upwards or to the front, see fig.
Key to fig.
•
Make sure that the refrigerator door is able to open at least 100°. Otherwise the
drawers cannot be used.
CAUTION!
Ensure the shelf is adequate to carry the total weight of the refrigerator
and the contents to be stored.
No.
Explanation
1
Cold intake air
2
Hot waste air
DometicHC302D-HC502D_IOM_4445101933_EMEA(en-de-fr-nl)_202x-xx-xx.book Seite 16 Mittwoch, 24. Februar 2021 2:57 14
