9.
Re-install mounting screws to refrigerator frame in
reverse sequence of steps B and C to attach door-
hinge assembly to refrigerator. DO NOT COM-
PLETELY TIGHTEN SCREWS.
h. CHECK THAT DOOR OPENS AND CLOSES
PROPERLY AND THAT LATCH ASSEMBLY
ENGAGES BEFORE TIGHTENING SCREWS.
NOTE: Re-tighten all screws securely after changing
the hinge position.
INSTRUCTIONS FOR MOUNTING
THE DOOR PANEL
The refrigerator is normally delivered without door panel.
Before starting the mounting work, check that the panel
dimensions are in compliance with those given in the
table and the instructions are read thoroughly.
When mounting the panel, proceed as follows):
A.
B.
C.
D.
E.
Remove the door de&ration strip (2) with its two
screws (1). The lower comers of the panel have to
be cut according to the sketch.
Insert one of the vertical edges of the panel into the
groove of the door frame (3).
Bend the panel gently so that the free side of the
panel can be slipped into the corresponding groove
of the door frame (4). Slide the panel down into the
groove of the bottom frame (5).
Between the upper edge of the panel and the door
frame there is now a gap which should be covered
by the decoration strip.
Put the decoration strip across the door so that the
gap is covered and push it upwards (6). The tabs on
the inside of the strip should fii in behind the flange
of the door frame. Secure the decoration strip by
means of the two screws removed in Step A (1).
Table 3
Panel Dimensions
Models S 1521, S
1531
21-19/32”x 36-1/16"
NOTE: Door panel thickness should not exceed 5/32”.
INSTRUCTIONS FOR REPLACING
CRISPER GLASS
FIG.
15
1.
Remove the retainers (see FIG. 15) by prying out
from side of liner with
a flat blade screwdriver being
careful not
to damage the liner.
2. After removing the retainers slide new glass in place
and install new retainers supplied with kit.
NOTE: Retainers should only be removed for re-
placement of crisper glass as they are not reusable.
8
Summary of Contents for Silhouette S1521
Page 14: ......
