7
B
Buuttttoonn ffuunnccttiioonnss
• Pressing the M
ME
EN
NU
U--bbuuttttoonn
gives you access
to the menu area. Choose the respective menu
using the UP- and DOWN-keys. The selection is
confirmed with the ENTER-button.
• Press the BACK-key
to return to the
previous screen or menu.
• Navigation within the menus and changing of the
settings are done using the U
UP
P
,, D
DO
OW
WN
N--
,,
LLE
EFFTT--
uunndd R
RIIG
GH
HTT
keys.
• Use the E
EN
NTTE
ER
R--kkeeyy
to confirm the actual
selection. This applies both for menu selection
and for parameter value. The change of a
parameter only becomes effective when
confirmed with the ENTER-key.
• In the case of an alarm, the acoustic alarm can be
switched off for a specified time with the “m
muuttee
bbuuttttoonn”. In Menu-mode the “mute button” is out
of function.
S
Seettttiinngg tthhee llaanngguuaaggee
• The factory language setting of the electronics is
ENGLISH. To convert to another language,
proceed as follows :
TThhee ““S
SE
ETTTTIIN
NG
GS
S””--M
Meennuu
• The parameters contained in the “SETTINGS” menu partially intervene in the function
of the appliance. Access to the SETTINGS menu can therefore be protected by a
password. It is recommended to use this protection to limit access to the parameters.
press the MENU-key
select “SETTINGS”
USER PASSWORD :
0XXX
In the factory setting this password is set to the value
“0000” so that by pressing the
- button you get
directly into the SETTINGS menu.
SET POINT
SET : X.X °C
The temperature set point is the set temperature of the
refrigerator. The set point can be altered
between the prescribed limit values in stages of 0.5 K.
press the MENU-key.
select EXTRA
LANGUAGE
select your language
TTeem
mppeerraattuurree D
Diissppllaayy
• During normal operation the display shows the
internal temperature of the refrigerator. The
temperature unit is dependent on the setting
“TEMP.UNIT” in the SETTINGS menu.
(°C - Celsius or °F -Fahrenheit).
• The display is carried out in steps of 0.1° or 1°
- depending on the setting “RESOLUTION” in the
SETTINGS menu.
S
Sw
wiittcchhiinngg oonn
• Check the setting of the circuit breaker. (see
chapter “
Fuse / Over-current Release”)
• To switch the unit on, turn the key switch in
horizontal position. The green power LED lights
up.
• After the self-test, the temperature inside the
refrigerator is displayed.
• The compressor will only switch on a certain time
after the self-test.
