25
25
E N G L I S H
Speed:
This function indicates estimated speed, either in km/h or mph,
depending on the position of the switch at the rear of the product (see
diagram).
Distance:
This function indicates estimated distance since the beginning
of the exercise session.
This can be displayed in km (kilometres) or M (miles) depending on the
position of the switch on the rear of the product.
Time:
This function indicates how much time has elapsed since the
beginning of the session; this indication is in Minutes : Seconds (MM : SS)
for the first hour, then it switches to Hours: Minutes (HH : MM)
Calories:
This function displays an estimation of calories expended since
the beginning of the exercise session.
RPM (Revolutions per minute):
Number of pedalling rotations per
minute.
Body Fat Level:
Body fat level measurement.
Heart rate*:
The heart rate is measured using the chest belt. Your heart
rate is displayed in beats per minute.
*Please note:
this figure is only an estimate and it should under no
circumstances be considered medically reliable.
*Attention :
*Please note: For a period of around 30-40 seconds, or
when there is a sudden change in heart rate, the value displayed may not
correspond to your actual heart rate. This is due to the mechanism starting
up.
*Please note:
A strong magnetic field may cause the number of heartbeats
counted to be affected.
FUNCTIONS
SETTINGS BEHIND THE CONSOLE
Switch 1 :
Selection of type of apparatus that you are using
with the console: VM (magnetic bike) ---- VE (elliptical bike)
Switch 2 :
Selection of unit of measurement for DISTANCE.
MI (Miles) ---- KM (Kilometres)
Switch 3 :
Selecting the device’s region of use: EU (Europe)/
AS (Asia)
SWITCH 1
SWITCH 2
SWITCH 3
RESET
transmitter
1. Parts and components
HEART RATE MONITOR BELT
Elastic belt
3V CR2032 Lithium Battery
Seal
Battery compartment cover
2. Installing the battery
• Insert the CR2032 battery (included) as shown below.
• First insert the battery with the + pole upwards.
• Place the seal and then the compartment cover with the two little
dots aligned.
Important !
Ensure that the compartment cover is fully tightened (approx. ½
turn) to avoid sweat or water getting into the compartment.
3. Using the belt
• Before placing the transmitter on your chest, moisten the two electrodes
with water or a water-based gel to ensure that the signal is transmitted
correctly.
• Center the heart rate monitor belt under your
breasts or pectoral muscles, directly above your
sternum, with the battery cover facing inwards.
• Adjust the belt so that the transmitter is always in full contact with your
skin. Do not overtighten it to avoid breathing diffi culties.
• If the heart rate monitor belt is loose or placed wrongly, you may get
erroneous or irregular readings.
VE 680 DIS.indd 25
VE 680 DIS.indd 25
09/11/10 14:38
09/11/10 14:38
