Downflo II, Models DFT 2-4 and DFT 3-6
11
1. The power packs are shipped assembled and
partial disassembly is required before installing.
2. Disassemble the power pack by removing the
blower housing fasteners and splitting the
blower halves. The motor half contains the
motor, half of the blower housing, and the
blower wheel.
3. Apply sealant to the collector toward the
inside-edge of the bolt pattern.
Note:
For all top-mounted TBI with and
without a blast-gate style damper, and
top-mounted TRB with a blast-gate style
damper, install a spacer ring between the
blower housing and the collector to
provide the necessary clearance for the
damper installation.
4. Mount the inlet half of the blower housing to
the collector using the hardware supplied.
5. Reassemble the motor half of the blower
housing the inlet half.
6. Rotate blower wheel after installation to ensure
proper clearance between the inlet cone and the
blower wheel.
FPS[IVLSYWMRK
QSXSVLEPJ
FPS[IVLSYWMRK
MRPIXLEPJ
MRHMEQIXIV
VSTIX]TIWIEPERX
LI\FSPX
JPEX[EWLIV
PSGO[EWLIV
LI\RYX
GSPPIGXSV
QSYRXMRKWYVJEGI
Power Pack Installation, TRB
