8
EN
switch without releasing the handle.
To switch on the power tool,
tilt the on/off switch
toward the right to the “I” position.
To switch off the power tool,
tilt the on/off switch
toward the left to the “O” position.
1:On
0:Off
Preselecting the orbital stroke rate
You can even preselect the orbital stroke rate during
operation using the necessary orbital stroke rate
preselection thumbwheel.
1
The rotation speed can be adjusted from 4000 r/min
to 12000 r/min by turning the speed adjusting dial to
give number setting from 1 to 6.
Higher speed is obtained when the dial is turned
in the direction of number 6. And lower speed is
obtained when it is turned in the direction of number
1.The required orbital stroke rate is dependent on
the material and the work conditions and can be
determined using practical tests.
Working Advice
Hold the tool firmly. Turn the tool on and then
slightly apply it to the workpiece. Generally, this
tool only applies to micro grinding for the surface of
workpieces. The grinding quality is more important
than the grinding amount and grinding rate. Thus,
do not apply strong pressure to grind. Keep the
baseplate aligned over the workpieces. Good finish
can be obtained on the furniture or fine surface if put
a cloth under the workpieces.
CAUTION:
•Never plug up the air outlet with your fingers or
hand.
•Never run the tool without the abrasive paper. You
may seriously damage the pad.
•This tool is not waterproof, and do not use water on
the workpiece.
Pull the plug out of the socket before carrying out
any work on the power tool.
Always wait until the power tool has come to a
complete stop before placing it down.
This power tool is not suitable for bench-mounted
use.
It must not be clamped into a vice or fastened to
a workbench, for example. For fatigue-free work, you
can hold the power tool from above, from the side or
from the front, depending on the application.
Maintenance and servicing instructions
Maintenance and cleaning
Pull the plug out of the socket before carrying out any
work on the power tool.
To ensure safe and efficient operation, always keep
the power tool and the ventilation slots clean.
If the replacement of the supply cord is necessary,
this has to be done by the manufacturer or his agent
in order to avoid a safety hazard.
Summary of Contents for ASA125
Page 1: ...DSA125 ASA125 KSA125 EN DE FR ES IT 3 11 21 31 41 ...
Page 2: ......
Page 51: ...51 IT ...
