GENERAL POWER TOOL SAFETY WARNINGS
(For All Power Tools)
WARNING! Read and understand all instructions.
Failure to follow all instructions listed below may result in electric
shock, fire and/or serious personal injury.
Save all warnings and instructions for future reference.
The term
“power tool” in the warnings refers to your mains-operated (corded)
power tool or battery-operated (cordless) power tool.
Work Area Safety
1.
Keep work area clean and well lit.
Cluttered or dark areas invite accidents.
2.
Do not operate power tools in explosive atmospheres, such as in the
presence of flammable liquids, gases, or dust.
Power tools create sparks
which may ignite the dust or fumes.
3.
Keep children and bystanders away while operating a power tool.
Distractions can cause you to lose control.
Electrical Safety
4.
Power tool plugs must match the outlet. Never modify the plug in
anyway. Do not use any adapter plugs with earthed (grounded) power
tools.
Unmodified plugs and matching outlets will reduce risk of electric
shock.
5.
Avoid body contact with earthed or grounded surfaces, such as pipes,
radiators, ranges and refrigerators.
There is an increased risk o electric
shock if your body is earthed or grounded.
6.
Do not expose power tools to rain or wet conditions.
Water entering a
power tool will increase the risk of electric shock.
7.
Do not abuse the cord. Never use the cord for carrying, pulling or
unplugging the power tool. Keep cord away from heat, oil, sharp edges
or moving parts.
Damaged or entangled cords increase the risk of electric
shock.
8.
When operating a power tool outdoors, use an extension cord suitable for
outdoor use.
Use of a cord suitable for outdoor use reduces the risk of electric
shock.
9.
If operating a power in a damp location is unavoidable, use a residual current
device (RCD) protected supply.
Use of an RCD reduces the risk of electric
shock.
NOTE:
The term “residual current device (RCD)” may be replaced by the term
“ground fault circuit interrupter (GFCI)” or “earth leakage circuit breaker (ELCB)”.
Personal Safety
10.
Stay alert, watch what you are doing and use common sense when operating
a power tool. Do not use a power tool while you are tired or under the
influence of drugs, alcohol, or medication.
A moment of inattention while
operating power tools may result in serious personal injury.
11.
Use personal protective equipment. Always wear eye protection.
Protective
equipment such as dust mask, non-skid safety shoes, hard hat, or hearing
protection used for appropriate conditions will reduce personal injuries.
12.
Prevent unintentional starting. Ensure the switch is in the off-position before
connecting to power source and /or battery pack, picking up or carrying the
tool.
Carrying power tools with your finger on the switch or energising power tools
that have the switch on invites accidents.
13.
Remove any adjusting key or wrench before turning the tool on.
A wrench or a
key left attached to a rotating part of the power tool may result in personal injury.
14.
Do not overreach. Keep proper footing and balance at all times.
This enables
better control of the power tool in unexpected situations.
15.
Dress properly. Do not wear loose clothing or jewellery. Keep your hair,
clothing, and gloves away from moving parts.
Loose clothes, jewellery or long
hair can be caught in moving parts.
16.
If devices are provided for the connection of dust extraction and collection
facilities, ensure these are connected and properly used.
Use of dust
collection can reduce dust-related hazards.
Power Tool Use and Care
-1- -2-
