Door Guard Pty Ltd
10
For more information please visit : www.doorguard.com.au
For Help and Support please send an email to : support@doorguard.com.au
3. Add IC card
Choose “IC cards” on APP, the lock will indicate “please swipe your card”, then swipe card on sensor
zone.
4. Add fingerprint
Choose “Fingerprints” on the APP, the lock will indicate “Please press your finger”, after you press your
finger, the lock will indicate “please press again”, then press your finger again.
5. Password unlock
Input ”password#”, If password verification is successful, the lock will be indicate “Unlocked”. If password
has been expired, the lock will be indicate “Invalid password”, If you repeatedly enter wrong passwords, the
lock will be indicate “illegal operation, the system is locked” or “operation failed”
Noted: If enter wrong codes, the user can enter ”*” to delete single wrong code then correct code
followed by ”#”.
6. Fingerprint unlock
Press registered finger on sensor zone, the lock will be indicate ”Unlocked” if successful or “operation
failed” if unsuccessful.
7. IC card unlock
After swipe card on sensor zone, the lock will be indicate ”Unlocked” if successful or “operation failed” if
unsuccessful.
8. Lock
The lock will automatically lock 5 seconds after unlocking, the lock will indicate ”Locked”.
9. Modify the user password
Enter*10#Old code#New code#Repeat new code#.
10.
Low power indication
When batteries are low, and the user touches the keypad to wake up lock
，
a warning tone will indicate ”low
power, please change battery”. At the same time backlight flashes one second.
11. Keypad lockout
After 5 unsuccessful attempts at entering a pin code, the lock will indicate ”failed” and will be unresponsive
for 5 minutes, Each time a code is entered the backlight will flash once to remind user the keypad is locked. IC
card, fingerprint, APP can be used to unlock in this state, and the pin code can be used again after unlocking.
