18
i n s t a l l a t i o n o f g a r a g e a n d i n d u s t r i a l s e c t i o n a l d o o r s
6
saFEtY ProVIsIons
Mounting must be carried out only with
working clothes that does not restrain move-
ment, protective helmet and gloves on .
during drilling of materials that can cause
shaving bouncing, during metal chipping
and cutting protective glasses must be used .
for respiratory organs protection against
construction dust a respirator must be used .
Hammer panes must have smooth, slightly
convex surfaces without dents, slants, cold
hardening, chips and chaps . Hammer shaft
length must not be less than 250 mm,
hammers must sit fixedly on shafts and
wedged . Hand holds of all tools with sharp
tips for them must be not less than 150
mm . Wooden hand holds must be tied up
with band rings . impact tools must not have
oblique and battered tails, cracks, burrs .
spanners must not have splits and nicks,
must match nuts and bolt heads dimensions;
spanner fingers must be parallel, must not
be worked out and rolled . to transfer work-
ing tools to the work place special bag or
chest must be used . use special belts to lay
tools during work . do not put tools in the
working cloth pockets .
safetY ProVisions for
WorK at a HeigHt
• Work at a height 1 .5 m and more above the
floor surface belongs to work performed at
a height . during work at a height safety belt
for mounting work must be used . if safety
belt fastening to the construction parts is
not possible, safety rope extended behind
construction parts in advance should be
used . in this case work must be performed
by 3 erectors . implements and tools must
be fixed to avoid their downfall during
work on constructions situated over alive
live parts .
• use of safety belts with metal chain slings
at work on constructions located over alive
live parts is forBidden .
• transfer of door elements, tools and imple-
ments for mounting upward must be carried
out using an endless rope . the rope must
be kept from swinging and approaching live
parts by the standing below worker .
It is forbidden:
• to stand under the ladder from which work
is carried out;
• to throw up any subjects in order to transfer
them upward, transfer must be performed by
means of a durable rope .
safetY ProVisions at WorK
WitH ladders
ladders must be equipped with a safety
device to prevent displacement and upset
during mounting . Bottom ends of the lad-
ders must have binding with sharp tips for
placement on the ground and for placement
of ladders on smooth surfaces (metal, slab,
concrete) they must be booted in rubber or
other slip resistant material .
It is forbidden:
• to work standing on the ladder step at less
than .
safetY ProVisions
1 m distance from its top;
• to operate power tool standing on ladders;
• to work standing on two upper steps of
ladders without railing or support;
• presence of more than 1 person on the ladder;
• to stand under the ladder from which work
is carried out;
• to put tools on ladder steps .
SAFETY PROVISIONS
