30
i n s t a l l a t i o n o f g a r a g e a n d i n d u s t r i a l s e c t i o n a l d o o r s
7
door mountInG
fasten the end plate with bearing to the u-shaped bracket using two bolts (М10х25) with suitable
nuts and washers . fasten the torsion gear on other side in a similar manner .
near
far
install the torsion gear in assembly so, that
the end plate with bushing is flush with the
bracket's external wall . Put on the shaft the
closing ring, it must abut on the bearing .
if the shaft consisting of two parts is being
installed, use the connection coupler to
enable adjustment of the cable .
connect two parts of the shaft using the coupler
and having inserted bushing keys in the key
slots of both parts of the coupler . tighten the
bolts connecting the coupler's parts .
