42
i n s t a l l a t i o n o f g a r a g e a n d i n d u s t r i a l s e c t i o n a l d o o r s
7
suPPLEmEnt
Door run check
after mounting the door movement must be checked . the door must move smoothly without
jerks . the rollers must not jam in the tracks . during installation of the doors in any intermediate
height position the door must not move spontaneously up or down .
if during the check the horizontal sidesway of the panels is observed, adjust tension of the
cables .
if the door leaf does not fir tightly to the embrasure the roller position should be adjusted .
lift the door leaf by 50 mm and lay wooden blocks under it . the position of the roller holders
must be adjusted so, that the rollers abut on the surface of the vertical track cavities . remove
the wooden blocks and close the door . check the backlash between the door leaf and the
embrasure, it must be 12 mm .
Operation and maintenance
Proper installation and maintenance of the doors secure reliability and long life of the prod-
uct . to extend durability of your doors follow these instructions . if you open or close the doors
manually do use the handle . do not apply force to open or to close the doors . Jerky opening or
closing of the doors is forbidden . if automatic operator is used follow instructions enclosed to
the operator .
do not open the doors by hand if the operator is clutched .
Keep children away from the automatic door control unit (buttons, control panels) . Keep
children and animals away from the door coverage during its functioning .
to go or to run under the moving door leaf is strictly prohibited, because it can cause seri-
ous injuries .
do not expose the door to impacts, do not hinder the door free opening and closing . the
tracks and the rollers must not be dirty, it can cause unevenness of the movement and if electric
drive is available it can cause its overload and breakdown .
see to it that during the door leaf movement there are no restrictions and debris in the
embrasure . their presence must cause sidesway and jamming of the door . do not touch movable
parts of the door (rollers, side supports, panels etc) during their functioning to avoid injuries .
in case of misuse of the door the manufacturer shall not be held responsible for its intact-
ness and proper functioning as well as possible injuries and future wrong to people, animals or
objects .
