i n s t a l l a t i o n o f g a r a g e a n d i n d u s t r i a l s e c t i o n a l d o o r s
45
9
suPPLEmEnt
ATTENTION: By installing the balance mechanism with two springs during assembling the right winding spring must be installed on the
left part of the shaft and the left winding spring on the right one.
drill the marked holes
∅
12 mm and fix the
intermediate bracket with tapping screws,
washers and dowels .
install the bearing in the plug's flange, and then
fix the flange with bolts М10х45 and nuts on
the multi-purpose internal bracket .
run the cable through the special technological
opening . tighten the squeezing screw, that is
fix the cable .
run the cable through the ear on the safety
coil . the amount of winding turns of the cable
for each door must be calculated particularly .
the data is presented in the mounting card .
in case of lack of the squeezing screw on the
drum drill in the side surface of the drums
the holes equal the cable's diameter to run
through the running end of the cable .
raise the assembled component and install in
the support brackets' bearing . Mark the holes
for multi-purpose internal bracket fastening to
the wall .
