i n s t a l l a t i o n o f g a r a g e a n d i n d u s t r i a l s e c t i o n a l d o o r s
47
9
suPPLEmEnt
Installation of lock for wicket
Place the lock housing against the panel
taking into account the length of the rod,
connecting it with the lock catch and mark the
holes for fastening of the lock under the lock
handle and its cylinder .
drill the marked holes 3 holes
∅
5 .5 mm for
fastening of the lock, under the lock handle
and cylinder using the drill
∅
19 mm .
the lock is recommended to be installed on
the second panel from below on the right side
of the door leaf (the premise inside view) .
Mark and drill 4 holes
∅
4 mm and 15-20 mm
deep from the inside of the door to fasten the
housing of the catch .
fasten with 4 tapping screws the catch housing
to the door panel .
open the door and drill
∅
15 mm hole in the
cornet support to enable the lock latch entry .
