Doorson 300 A, User Manual

PRODUCT PURPOSE

Automatic sliding doors product line 300 can be used as interior or exterior doors . The drive is advised to 

be installed inside the building, otherwise a canopy is recommended . In the product line 300 the 300F and 

300EF doors are fireproof doors . The 300 THALES r, 300 r, 300 T r, 300 P r, 300 SC r, 300 C r, 300 A and 

300 EF are suitable for the installation on escape routes and emergency exits .

Automatic sliding doors product line 300 may only be used according to its specified intended use . 

Doorson will not accept any liability for damage resulting from unauthorized modification of 

product line 300 or inappropriate use . Furthermore, components/accessories that have not been approved 

by Doorson are exempted from liability .

It is important for the safety of persons to follow these instructions:

• 

do not allow children to play with automatic doors;

• 

always escort children when walking through automatic doors;  

• 

frequently examine the door status (signs of wear, inadequate functioning and damage to  

cables or moving parts) . Do not allow door operation if repair or adjustment is necessary;

• 

disconnect the power supply (230VAC and battery unit) during maintenance works inside  

  the 

drive;

• 

change the door mode to STOP during the cleaning of the door leaves;

• 

follow all instructions since incorrect installation can lead to severe injury;

• 

properly ground the door leaf/leaves if Product line 300 is installed on a metal    

  construction;
 

• 

door leaves with glass must be made of safety glass;

• 

there should be no contact between glass and hard materials during operation if the leaves  

are made from glass only .;

During the planning of 

automatic sliding doors product line 300, the manufacturer (the person installing 

the system) and the commissioner/facility operator have to perform an individual risk assessment 

together . All the data is included in the SAFETY ANALYSIS document . 

6

 I 

USER MANUAL

DANGER SPOTS:

 Automatic doors might cause hazards like 

crushing, shearing, hitting and drawing-in at the closing edges .

RESIDUAL RISK: 

Depending on the structural conditions, the 

prevailing door version and the available safety equipment, 

residual risks such as crushing and hitting (with a limited force) 

cannot be excluded .

A 

– main closing edge

B

 – secondary closing edge

Danger spots