PARTS ORDERING
75
12/150_23136591
−
C en
GENERAL
This publication, which contains an illustrated parts
breakdown, has been prepared as an aid in locating
those parts which may be required in the maintenance
of the unit. All of the compressor parts, listed in the
parts breakdown, are manufactured with the same
precision as the original equipment. For the greatest
protection always insist on genuine Doosan parts for
your compressor.
NOTICE
Doosan can bear no responsibility for injury or damages
resulting directly from the use of non
−
approved repair
parts.
Doosan Infracore service facilities and parts are
available worldwide.
There are Authorised Distributors or Company Sales
offices in principal cities of many countries.
Special order parts may not be included in the manual.
Contact Doosan Parts Department with the unit serial
number for assistance with these special parts.
DESCRIPTION
The illustrated parts breakdown illustrates and lists the
various assemblies, subassemblies and detailed parts
which make up this particular machine. This covers the
standard models and the more popular options that are
available.
A series of illustrations show each part distinctly and in
location relative to the other parts in the assembly. The
part number, the description of the part and the quantity
of parts required are shown on each illustration or on
adjacent page. The quantities specified are the number
of parts used per one assembly and are not necessarily
the total number of parts used in the machine. Where
no quantity is specified the quantity is assumed to be
one.
Each description of a part is based upon the “noun first”
method, i.e., the identifying noun or item name is
always the first part of the description. The noun name
is generally followed by a single descriptive modifier.
The descriptive modifier may be followed by words or
abbreviations such as upper, lower, inner, outer, front,
rear, RH, LH, etc. when they are essential.
In referring to the rear, the front or to either side of the
unit, always consider the
drawbar
end
of the unit as the
front.
Standing at the rear of the unit facing the
drawbar (front) will determine the right and left sides.
FASTENERS
Both SAE/inch, ISO/metric hardware have been used
in the design and assembly of these units. In the
disassembly and reassembly of parts, extreme care
must be taken to avoid damaging threads by the use of
wrong fasteners. In order to clarify the proper usage
and for exact replacement parts, all standard fasteners
have been identified by part number, size and
description. This will enable a customer to obtain
fasteners locally rather than ordering from the factory.
These parts are identified in tables that will be found at
the rear of the parts illustrations. Any fastener that has
not been identified by both part number and size is a
specially engineered part that must be ordered by part
number to obtain the exact replacement part.
