The alternator is maintenance-free, nevertheless, it must be protected against dust and,
above all, against moisture and water.
Operate the alternator according to the instructions given in the chapter.
3.11.3. Starter motor
The sliding-gear starter motor is flanged to the rear of the flywheel housing on the left-hand
side. When the starting key switch is turned on, the starter motor pinion flies out and engages
the ring gear of the flywheel. Then the main contact is closed, current flows, and the engine
is started. After the engine starts, the pinion automatically returns to its initial position when
the starting key switch is released. Once the engine starts, the starting key switch should be
released immediately. Otherwise, the starter motor may be damaged or burned out.
In case of repairing the engine dip the pinion of the starter and ring gear into the fuel and
remove the corrosion with brush. After that apply the grease on them to protect the corrosion.
Whenever you clean the starter, always pay attention not to occur the electric short due to
entering the water.
- 25 -
To B
EA8O3007
Regulator
RL = 150~250 OHM
Wiring Diagram
Summary of Contents for D1146
