5.2.3. Oil exchange procedure
While the oil is still hot, exchange oil
as follows:
•
Take out the oil dip dipstick.
•
Remove the drain valve from oil pan,
then drain out the engine oil into a con-
tainer.
•
Reassemble the drain valve with the oil
pan and the drain plug with oil filter head
after draining out the engine oil.
•
Refill with new engine oil at the oil filler
neck on the head cover and the lubricat-
ing oil in accordance with the oil capaci-
ty of the engine through oil filler. Be care-
ful about the mixing of dust or contami-
nator during the supplement of oil. Then
confirm that oil level gauge indicates the
vicinity of its maximum level.
•
For a few minutes, operate the engine at
idling in order to circulate oil through
lubrication system.
•
Thereafter shut down the engine. After
waiting for about 10 minutes measure
the quantity of oil and refill the additional
oil if necessary.
•
Recommend of lubricating oil
Initial factory filling is high quality break-in oil (API Service CH-4 grade). During the break-in
period (50 hours), check the oil level frequently. Somewhat higher oil consumption is normal
until piston rings are seated. The oil level should be maintained in the safe range between Min.
and Max. mark on the dipstick. To obtain the best engine performance and engine life, Engine
oil is specified by API Service, lettered designations and SAE viscosity numbers. If the speci-
fied engine oil is not available, use a reputable brand of engine oil labeled for API Service CH-
4 and SAE viscosity 15W40 or 10W40. Refer to oil identification symbol on the container.
- 33 -
EA9O4001
EA9O4002
Summary of Contents for D1146
