5.5. Fuel System
5.5.1. Fuel filter
•
After every 200 hour of operation, drain
the water and sediment from the fuel-
water separator.
•
Shut off the engine. Use your hand to
open the drain valve .
•
Turn the valve counter clockwise approx-
imately 2 ~ 3 turns until draining occurs.
Drain the filter sump of water until close
fuel is visible.
•
Turn the valve clockwise to close the
drain valve. Do not over tighten the valve,
overtightening can damage the threads.
5.5.2. Replacement of fuel filter
•
Clean the area around the fuel filter head
aa
.
•
Remove the fuel filter by turning it
counter-clockwise with filter wrench.
(Discard the used filter.)
•
Remove the fuel filter thread adapter seal
ring .
•
Use a clean lint free cloth to clean the
gasket surface of the fuel filter head .
•
Install the new thread adapter seal ring
aa
supplied with the new filter.
•
Use clean oil to lubricate the filter seal
aa
, and fill the new filter with clean fuel.
•
Install the filter on the filter head .
•
Tighten the filter until the gasket contacts
the filter head surface.
•
Tighten the filter on additional one-half to
three-fourths of a turn with the filter
wrench, on as specified by the filter man-
ufacturer.
NOTE :
Mechanical over tightening of the filter can distort the thread or damage the filter ele-
ment seal.
- 40 -
1
5
2
3
4
6
EA2O4009
EA7O5008
1
3
2
4
4
3
3
5
EA204009
Summary of Contents for D1146
