OP001015
Inspection, Maintenance and Adjustment
4-30
5.
Do not force the belts into the pulley grooves by prying with
a screwdriver or pry bar. This will damage the belt side
cords which will cause the belts to turn and result in
complete destruction of the belts in operation.
6.
Belts on new machines and replacement belts lose their
tension as they seat into the pulley grooves. Check the
tension of new belts at 20 hour intervals until tension is
stabilized and thereafter, every 250 hours. If the tension
falls below the required minimum, the belt will be able to
slip, damaging the belts and pulley grooves.
NOTE:
When operating in abrasive conditions, check
tension every 100 hours.
Check Air Intake System
1.
Park the machine on a level surface, apply the parking
brake, lower the attachment to the ground, and shut down
engine.
2.
Check the engine intake hose, and hose clamps for
damage and tightness.
3.
If damaged, wrinkled or loose, replace, tighten or contact
your nearest
DOOSAN
loader dealer.
Figure 31
HAOA050L
WARNING
Hot engine components can cause burns.
Avoid contact with hot engine components.
Figure 32
IMPORTANT
Severe engine damage will result from running with
unfiltered air.
Do not operate engine if any leaks or defects are found
on air intake system.
Summary of Contents for DL220
