OP000530
Inspection, Maintenance and Adjustment
4-72
BUCKET
Bucket Tooth Replacement
NOTE:
These instructions are only for DOOSAN OEM
buckets. If you are using other manufacturers
buckets, refer to their specific instructions.
1.
On a routine basis, inspect bucket teeth to make sure that
tooth wear or breakage has not developed. Do not allow
replaceable bucket teeth to wear down to a point that
bucket adapter is exposed. See Figure 140.
2.
To replace a tooth (1, Figure 141), use a hammer and
punch to drive locking pin (2) and lock washer (3) out of
tooth adapter (4).
3.
Once worn tooth has been removed, use a putty knife to
scrape adapter as clean as possible.
4.
Slide new tooth into position and insert lock washer.
5.
Insert locking pin into tooth and with a hammer, drive pin in
until lock washer seats in locking groove.
WARNING!
Due to the possibility of flying metal objects, always wear
safety helmet, protective gloves and eye protection when
changing bucket teeth.
Curl the bucket upwards and place the round rear surface
of the bucket firmly on the ground. Shut the engine off and
lock out the hydraulic controls before working on the
bucket.
HAOC680L
Figure 140
2
4
3
FG000346
1
Figure 141
Summary of Contents for DX190W
