DX380LC-7
Operation
3-88
General Information
The following maintenance table contains an overview of the
inspections and maintenance work that must be performed
regularly.
The maintenance intervals depend on customer-specific settings
and operating conditions. The customer is therefore responsible
for determining and observing the maintenance intervals on its
own.
NOTICE
All work beyond this scope must be performed by
authorized Service establishments.
Maintenance Work
Action
Interval
Check of fill level in
lubricant reservoir
Refill if necessary.
Depends on planned lubricant consumption
Inspection of system
components (lubricant
lines, connection points,
seals, etc.) for leaks
Parts that exhibit leaks must be
replaced. Please contact to service
office.
After each refill of the lubricant reservoir
or after long operational pauses before
commissioning the machine/vehicle
Visual inspection of
bearings' lubrication
In case of insufficient bearing
lubrication, a fault in the lubrication
system or incorrect system configuration
is the probable cause. Observe the
instructions contained in these
operating instructions. If necessary,
contact to service office.
In conjunction with lubrication reservoir
filling
Check of basic function
of control unit and
system components
To inspect the basic functions, trigger
an interim lubrication by pressing the
key
After each lubrication reservoir filling
Inspection of electrical
cables for damage
Damaged cables must be replaced.
Please contact to service office.
After long operational pauses before
commissioning the machine/vehicle
Inspection of electrical
connections and contacts
for firm attachment
and corrosion
Tighten loose contacts. Clean any
corroded electrical contacts with a wire
brush, then apply a small amount of
contact grease after installation
Semi-annual
