DX380LC-7
Safety
1-26
Electrical System and Electrical Shock
Ensure electric line to NOT be short-circuited. Shorting could
damage electrical system and engine neutral start system.
Engine running generates high voltage through injector terminal
and engine controller, and it remains residual immediately after
the engine stopped. Do not contact injector terminal or engine
controller inside.
NOTE:
Contact your DOOSAN distributor to access injector
terminal or engine controller inside.
Roll-over Protective Structure (ROPS)
The operator's cabin is a ROPS certified structure for protecting
the seat-belted operator. It absorbs the impact energy of a roll-
over impact. Do not allow machine weight (mass) to exceed
certified value on certification plate. If weight is exceeded, the
ROPS structure will not be able to fulfill its safety function.
Do not increase machine weight beyond certified value by
modifying machine or by installing attachments on machine. If
weight limit of protective equipment is exceeded, protective
equipment will not be able to protect operator, and this can
result in death or serious injury. Always observe the following:
•
This machine is equipped with a protective structure. Do
not remove protective structure and perform operations
without it.
•
Never modify the operator's cabin by welding, grinding,
drilling holes or adding attachments unless instructed by
DOOSAN in writing. Changes to the cabin can cause loss
of operator protection from roll-over and falling objects, and
result in death or serious injury.
•
When protective structure is damaged or deformed by
falling objects or by rolling over, its strength will be reduced
and it will not be able to adequately protect the operator.
Contact your DOOSAN distributor if you have any
questions about the ROPS. Never repair a damaged
ROPS cabin.
•
Always wear your seat belt when operating machine.
