DX380LC-7
Safety
1-40
1.
Front mirror on the cabin (1)
If equipped, adjust the front mirror on the cabin (1, Figure
27) so the front of the right track can be seen from the
operator seat.
2.
Front mirror on the cabin (2)
If equipped, adjust the front mirror on the cabin (2, Figure
27) so the front of the left side can be seen from the
operator seat.
3.
Additional mirrors other than Figure 27
If equipped, adjust the mirrors whenever you change
operators and ensure the mirrors are in proper working
conditions.
Work Site Rules
•
If visibility cannot be sufficiently assured, use a flagman.
The operator should pay careful attention to signals and
follow instructions from flagman.
•
Signals should only be given by one flagman.
•
When working in dark places, turn "ON" work lights and front
lights on the machine. Set up additional lighting in area.
•
Stop operations if there is poor visibility, such as fog, snow,
rain, or sandstorms.
•
Check mirrors and rear/side view camera (if equipped) on
machine before starting operations. Clean off any dirt and
adjust view for good visibility.
When operating or traveling during poor visibility conditions,
follow the preceding work site rules.
It may not be possible to adjust all visual aids to see all the way
around the machine. Therefore, additional precautions such as
flagman, barricades, etc., must be taken to keep other personnel
out of the work area.
DS1801222
Figure 32
DS1801380
Figure 33