DX380LC-7
Safety
1-20
Personal Protective Equipment (PPE)
Do not wear loose clothing and accessories. Secure long hair.
These items can snag on controls or on other parts of
equipment.
Do not wear oily clothes. They are highly flammable.
Do not forget that some risks to your health may not be
immediately apparent. Exhaust gases and noise pollution may
not be visible, but these hazards can cause disabling or
permanent injuries. Breathing masks and/or ear protection may
be required.
Wear a hard hat, safety shoes, safety goggles, mask, leather
gloves, earplugs and other protective equipment, as required.
While working on machine, never use inadequate tools. They
could break or slip, or they may not adequately perform intended
functions.
Correction of Machine Problems
If any machine problems are found during operation and
maintenance (noise, vibration, smell, incorrect gauges, smoke,
oil leakage, etc.), or if any abnormal warning alerts are displayed
on display monitor, stop the machine and take the necessary
corrective actions. Do not operate machine until problem has
been corrected.
Crushing and Cutting
Keep objects away from moving fan blades. Fan blades can
throw and cut objects.
Do not use a wire rope that is kinked or frayed, or a wire rope
with any loss of diameter. Wear leather gloves when handling a
wire rope.
When striking a loose retainer pin, it can fly out and can cause a
serious injury. Make sure that area is clear of personnel when
striking a retainer pin. To avoid injury to your eyes, wear safety
goggles when striking a retainer pin.
Do not put your hand, arm or any other part of your body
between movable parts. If going between movable parts is
necessary, always position and secure work equipment so it
cannot move. Properly support equipment before performing
any work or maintenance under raised equipment.
If control levers are operated, clearance between machine and
work equipment will change and this may lead to serious
damage or can result in death or serious injury. Stay clear of
areas that may have a sudden change in clearance with
machine movement or equipment movement. Stay clear of all
rotating and moving parts. Unless instructed, never attempt
adjustments while machine is moving or while engine is running.
HAOA020L
Figure 7
