G80XW/XF, G115XW/XF, G150XW/XF, G200XW/XF - 50HZ
OPERATION & MAINTENANCE MANUAL
32
G100XW/XF, G135 XW/XF, G170XW/XF, G225XW/XF - 60Hz
Load
These pages contain electrical values of the load,
measured or derived from the module’s voltage and
current inputs. The power values displayed depend on
which supply is on load.
•
Generator Current (A)
•
Mains Current (A) (DSE7110 MKII only)
•
Load ph-N (kW)
•
Total Load (kW)
•
Load ph-N (kVA)
•
Total Load (kVA)
•
Load ph-N (kVAr)
•
Total Load (kVAr)
•
Power Factor ph-N
•
Power Factor Average
•
Accumulated Load (kWh, kVAh, kVArh)
Engine
These pages contain instrumentation gathered about the
engine measured or derived from the module's inputs,
some of which may be obtained from the engine ECU.
•
Engine Speed
•
Engine Run Time
•
Engine Battery Volts
•
Engine Coolant Temperature
•
Engine Oil Pressure
•
Engine Fuel Level
•
Flexible Sensor
•
Engine Maintenance Due - Oil
•
Engine Maintenance Due - Air
•
Engine Maintenance Due - Fuel
Info
These pages contain information about the controller.
•
Module's date and time
•
Scheduler settings
•
Product description and USB identification
number
•
Application and Engine Version
Event Log
This module’s event log contains a list of the last 50
recorded events and the engine hours at which they
occurred. The events recorded are customisable via the
DSE Configuration Suite PC Software.
Example below shows the possible configuration of the
event log (DSE Configuration Suite Software). This also
shows the factory settings of the module.
Once the log is full, any subsequent event overwrites the
oldest entry in the log. Hence, the log always contains
the most recent events. The module logs the alarm,
along with the engine running hours.
Icon to indicate the
scheduler is currently
displayed
Start time of
scheduled
run
Duration of
scheduled run
Day and week of
scheduled run
