Operating Instructions
Operation & Maintenance Manual
23221138 (5/08) Rev B
31
Gasoline Unit
•
IF the receiver is pressurized OR the engine is cold, activate the hand unloader valve
accessible through the hand hole in the side panel under the radiator. The aluminum
toggle should be flipped so as to pull the valve rod outward.
•
Pull choke know all the way out.
•
Insert key into power switch.
•
Depress and hold bypass switch.
•
Turn power switch fully clockwise to "START" position to crank engine. Hold switch
in "START" position for approximately 5 seconds after engine starts.
•
Return switch to "RUN" position.
•
Release bypass switch after engine attains full speed.
•
Slowly push choke knob all the way in until engine runs smoothly.
NOTICE
Do not operate the starter motor for more than 10 seconds without
allowing at least 30 seconds cooling time between start attempts.
•
Allow engine to warm up about 5 minutes.
•
Flip hand unloader toggle valve back to the run position.
•
Unit is now ready to supply service air.
Summary of Contents for Ingersoll Rand VHP40RMD
