Look for these signs on machines shipped to markets in North America, which point out potential hazards
to the safety of you and others. Read and understand thoroughly. Heed warnings and follow instructions.
If you do not understand, inform your supervisor.
DANGER
CAUTION
Red Background
Indicates the presence of a hazard which WILL cause
serious injury, death or property damage, if ignored.
Yellow Background
Indicates the presence of a hazard which WILL or can
cause injury or property damage, if ignored.
WARNING
NOTICE
Orange Background
Indicates the presence of a hazard which CAN cause
serious injury, death or property damage, if ignored.
IR2PS, IR3PS and IR5PS Pickhammers are designed for breaking concrete and other demolition work
in construction applications.
Ingersoll–Rand is not responsible for customer modifications of tools for applications on which Ingersoll–
Rand was not consulted.
The use of other than genuine Ingersoll-Rand replacement parts may result in safety hazards, decreased tool
performance, and increased maintenance, and may invalidate all warranties.
Repairs should be made only by authorised trained personnel. Consult your nearest Ingersoll-Rand Authorised
Servicenter.
IMPORTANT SAFETY INFORMATION ENCLOSED.
READ THIS MANUAL BEFORE OPERATING TOOL.
IT IS THE RESPONSIBILITY OF THE EMPLOYER TO PLACE THE INFORMATION
IN THIS MANUAL INTO THE HANDS OF THE OPERATOR.
FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
Blue Background
Indicates important set-up, operating or maintenance
information.
NOTICE
WARNING
NOTICE
PLACING TOOL IN SERVICE
•
Always operate, inspect and maintain this tool in
accordance with all regulations (local, state, federal
and country), that may apply to hand held/hand
operated pneumatic tools.
•
For safety, top performance, and maximum durability
of parts, operate this tool at 90 psig (6.2 bar/620 kPa)
maximum air pressure at the inlet with 1/2” (13 mm)
inside diameter air supply hose.
•
Always turn off the air supply and disconnect the air
supply hose before installing, removing or adjusting
any accessory on this tool, or before performing any
maintenance on this tool.
•
Do not use damaged, frayed or deteriorated air hoses
and
fittings.
•
Be sure all hoses and fittings are the correct size
and are tightly secured.
•
Always use clean, dry lubricated air at 90 psig
(6.2 bar/620 kPa) maximum air pressure. Dust,
corrosive fumes and/or excessive moisture can ruin
the motor of an air tool.
•
Do not lubricate tools with flammable or volatile
liquids such as kerosene, diesel or jet fuel.
•
Do not remove any labels. Replace any damaged labels.
USING THE TOOL
•
Always wear eye protection when operating
or performing maintenance on this tool.
•
Always wear hearing protection when operating
this
tool.
•
Keep hands, loose clothing and long hair away from
rotating end of tool.
•
Anticipate and be alert for sudden changes in motion
during start up and operation of any power tool.
•
Keep body stance balanced and firm. Do not overreach
when operating this tool.
•
Tool accessories may continue to impact briefly after
throttle is released.
•
Air powered tools can vibrate in use. Vibration,
repetitive motions or uncomfortable positions may be
harmful to your hands and arms. Stop using any tool
if discomfort, tingling feeling or pain occurs. Seek
medical advice before resuming use.
•
Use accessories recommended by Ingersoll-Rand.
•
This tool is not designed for working in
explosive
atmospheres.
•
This tool is not insulated against electric shock.
15
EN
Summary of Contents for IR2PS
