4-12 Inspection, Maintenance and Adjustment
022-00029AE Operation and Maintenance Manual
REFILL FUEL
1.
At end of each work day, fill fuel tank. Add
fuel through fuel filler pipe (Figure 13).
When working at a temperature of 0°C
(32°F) or higher, use ASTM No. 2-D or its
equivalent. At temperatures below 0°C
(32°F) use ASTM No. 1-D or its equivalent.
NOTE:
See “Fluid Capacities” on
page 4-5 for capacity.
2.
Securely tighten cap after fueling.
NOTE:
If breather holes in cap are
clogged, a vacuum may form in
the tank preventing proper fuel
flow to engine. Keep holes in
fuel cap clean.
CHECK FOR LEAKS IN THE FUEL SYSTEM
1.
Perform an inspection of engine
compartment to verify that fuel system is
not leaking. If any is noted, determine the
source of leak and repair.
DRAIN FUEL CONDENSATION
1.
Open fuel tank drain valve. (Figure 15). Allow any condensed water or sediment to drain out of tank.
Also open drains on Primary and Secondary fuel filters and drain out any water or sediment. (Figure
16). Catch drained material in a container. Properly dispose of drained material.
WARNING!
Use extreme safety precautions while
refueling to prevent explosions or fire.
Immediately clean up any spilt fuel.
Figure 13
HAOC510L
Figure 14
Figure 15
Figure 16
