2-8 Operating Controls
022-00029AE Operation and Maintenance Manual
F.
Push Down - Locks into position and
lights up the high beams.
G.
Neutral Position - Normal low beams.
H.
Pull Up - Momentarily turns "ON"
both the low and high beams. (Lever
returns to "NEUTRAL" position when
released.)
NOTE:
High and low beams will only
function with the headlight
switch in the
"||"
position.
4.
ACCELERATOR PEDAL
Controls the travel speed of loader and
working speed of load handling system.
5.
STEERING TILT KNOB
This knob is used to allow steering wheel
to be moved to the most convenient
position for the operator. Loosen knob (2,
Figure 10), while grabbing the steering
wheel (1). Once the steering wheel is in
the proper place, tighten the knob.
CAUTION!
The further the pedal is pressed, the
more engine speed increases.
However, do not press the pedal
more than necessary; otherwise it
will increase fuel consumption,
cause short life on the engine, and in
the worst case lead to a serious
accident.
F
G
H
HAAA4350
Figure 8
Figure 9
1
2
HBOI200L
Figure 10
