5
F: TROUBLE SHOOTING
Please check the followings before having the machine repaired.
PROBLEMS
POSSIBLE CAUSES
ELMINATION
Not hot or cold
water
1. Over consumption of hot or
cold water in short time.
2. No power supply
1. Just wait a moment, then hot or
cold water is available again.
2. Connect plug to socket, turn on
heating or cooling switch.
No water
running out
from taps
1. Empty bottle
2. Inlet of bottle supporter
blocked by bottle seal
1. Replace it with another one.
2. Clean out wasted paper & bottle
seal, install bottle again
Leakage from
bottle supporter Broken bottle
Replace it with a new bottle
Noisy operation Not placid installation
Place the machine on placid &
solid surface
G: CLEANING
To avoid accident, cut off the power supply before operation according to the following
instruction.
1.The machine had been disinfected before departed from factory.
Cleaning the dispenser prior to installing a full bottle of water for the first time.
2.Cleaning and draining instruction:
a) Before cleaning, make sure the power switch in the O(off) position and unplug the water
dispenser.
b) Vertically insert the bottle into the supporter on the top of the machine.
c) Turn on all the taps in turn for 3 minutes after the water outflow, which completes the internal
pipeline flushing.
d) Removed the water bottle from the dispenser.
e) Place a large bucket beneath the drain outlet. Remove the drain cover and allow water to
drain.
f) After cleaning, replace the drain cover and you can use the machine.
Attention:
The dispenser heats water to a temperature of approximately 85°C. It can cause
severe burns. Please operation it carefully.
3. Sanitizing
The machine should be disinfected with the disinfectant separately bought from drugstore or
marketplace according to the instruction manual of the disinfectant and then clean it with water
(see cleaning and draining instruction). Generally this should be done every three months.
4. To remove mineral deposits:
Mix 4 liters water with 200g citric acid crystals, inject into the machine and make sure the water
can flow out of the hot water tap. Switch on the power and heat it about 10 minutes, 30 minutes
later, drain off the liquor and clean it with water for two or three times. Generally this should be
done every six months.
Never disassemble this machine by yourself to avoid danger from damaged machine.
