LATCH:
Comes with a single, attached LATCH strap. Earlier models which are not LATCH-
equipped may be installed with the Dorel Cosco LATCH retrofit kit (see also separate
instructions for kit). If the child is using the harness, LATCH installation may be used. Thread
both ends of the strap through the belt path. Lower LATCH bars may be used in center seating
position when the position is designated as a LATCH location in vehicle owner's manual or
when vehicle manufacturer permits the use of the outboard bars (refer to Safe Ride News
LATCH manual).
If LATCH strap is not in use, hook LATCH connectors together behind seat to
prevent them from striking anyone. LATCH strap is not used in belt-positioning booster mode.
Tether:
Yes, when seat is used with harness. There are three adjustment versions. If there are
two double-slotted metal slides, thread as shown in diagrams 4-5. If there is one metal slide with
three slots, thread as shown in diagram 6. Some recent models have a tilt-lock adjuster; simply
pull on strap end to tighten. In either case, attach strap to seat shell as shown in diagram 7.
When not in use, including as a belt-positioning booster, secure the hook under the seat or
remove tether from seat completely. See full manufacturer’s instructions for additional
guidelines on adjusting tether strap snugly and storing when not in use.
Other:
On some models, the two parts of the buckle prongs must be joined
together before inserting in buckle (diagram 9).
DOREL brands include: COSCO, EDDIE BAUER, SAFETY 1st,
ALPHA ELITE and ALPHA SPORT. Model names may apply to any one or more of these
brands. Some model names may be discontinued.
There have been many variations of this seat with several model names, which are
usually not printed on the seat. Use these instructions only if the seat has a front adjuster strap.
See other instructions for models with a metal plate in the back to adjust the harness or the
original Cosco combination seat called “Highback Booster,” which had straps crossed in the
back with a metal slide for harness attachment and adjustment. Some models have armrests
and cup holders.
Page 2 of 2
Dorel Commuter / Ventura / HBB (front adjuster)
Important: This information sheet is not a substitute for complete manufacturer’s directions and current recall list.
SafetyBeltSafe U.S.A., P.O. Box 553, Altadena CA 91003 (310) 222-6860 (800) 745-SAFE ©SafetyBeltSafe U.S.A. #48 01/07
6
5
4
7
9
