11
12.
From the Back, Pull
Harness Straps Through
Shell
Harness straps
MUST
be in shoulder
harness slots
BELOW
the metal bar as
shown.
DO NOT
twist harness straps.
13.
Attach 2nd Harness Strap
Loops to Splitter Plate As
Shown
Sewn ends of the harness strap loops
MUST
face towards you.
DO NOT
twist harness straps or harness
adjustment strap.
Make sure the same harness strap loops
are fitted
COMPLETELY ON
both sides
of the splitter plate.
Replace headrest pad around bottom
of headrest.
sewn
end
12
Correct
WARNINGS:
Harness system must be installed correctly.
The harness strap must be returned to the upper shoulder
harness slots as your child grows.
Failure to follow these steps can result in serious injury or
death.
11.
Pull Bottom of Headrest
Pad Off of Headrest
Thread harness straps through slots in
headrest pad.
Thread harness straps through lower
shoulder harness slots in headrest and
through the slots in seat back (shell).
7.
Fully Loosen Harness
Straps
Push down on harness release lever
(under fl ap on front of seat pad) while
pulling out on harness straps as shown.
6.
Adjust the Headrest to the
Lowest Position
The headrest
MUST
be in the lowest
position.
8.
From Back, Remove Harness
Strap Loops From Splitter
Plate
9.
Pull Harness Straps Out of
Upper Shoulder Harness
Slots
10.
Pull Body Pillow Forward
Away from Seat
Thread harness straps through slots in
pillow.
You
MUST
use the body pillow.