D'Orly CUPRO 3D, User Manual

4

5

PRODUCT OVERVIEW

Horizontal Laser

Vertical Laser

Vertical Laser

Vertical L

aser S

witch

Detector mode

Horizontal L

aser S

witch

Tilt L

ock S

witch

ON / OFF

Switch

OPERATION

Only move the CUPRO laser in the “OFF” state. 

(3)

 This locks the laser emitters 

in their place and prevents damage or decalibration as a result of excessive 
movement.

1)   (Optional) Fix the Cupro laser to the desired accessory, such as a tripod or 
  magnetic bracket. Make sure the connection is secure and the placement is 
 reliable.
2)  Move the instrument as close to the desired position as possible, as close to 
  level as possible.
3)  Turn on the instrument using the ON/OFF switch. 

(3)

 The instrument will 

  auto-level within 2,5°. If the placement deviates more than 2,5° from level 
  the laserbeams will keep fl ashing.  
4)  Turn on the desired laser emitters by pressing the “V” or “H” buttons. 

(2)

Pressing the “V” button multiple times switches between the on/off  states of 

  each vertical laser beam. Pressing the “H” button multiple times switches 
  the horizontal laser beam on or off .
5)  Micro-adjustments can be made in the ON-state by 

carefully

 moving the 

  instrument a few millimeters in place.

DETECTOR

1)  When using an optional laser detector the working range can be doubled. 
  Switching on the detector function on the control panel 

(3)

 will activate 

  the high frequency pulse needed for detection. This cannot be detected 
  with the naked eye, the laserbeams will look less bright.

TILT FUNCTION

The tilt function enables the instrument to emit laser beams in an angled 
position. To use the tilt function:

1)  Keep the “ON/OFF” switch in the “OFF” position. 

(3)

2)  Press the “Lock” button on the control panel. 

(2)

3)  Enable the desired laser emitters by pressing the corresponding buttons on 
  the control panel.
4)  To switch off  the device press the “Lock” button again.