22
ED50/ED100/ED250
09-2021
DL4617-003
dormakaba ED50/ED100/ED250 OHC Header
Setup and Troubleshooting Instructions
Chapter 10
10 Parameters
Step 1
Press right button greater than 3 s to
enter program mode.
Step 2
Press up or down button to scroll through
parameters until desired parameter is
displayed.
Step 3
Press right button to display current
parameter value.
Step 4
Press right button again to enable
editing of value, display will start
flashing.
Step 4
Press up or down button to select
desired parameter value.
Step 5
Press right button to save selected
value. Display stops flashing.
Step 6
Press left button to return to selected
parameter.
Step 7
Press up or down button to scroll
through parameters until next desired
parameter is displayed.
Step 8
Press left button for a minimum of 3 s
to exit program mode.
10.3.1 Driving parameters.
Driving parameters (Table 10.3.1) can be set once initial
setup (Chapter 10) has been completed.
• Reference Appendix A for driving parameter detail.
10.1.1 Changing parameter values.
1. Set Mode switch to the CLOSE position
.
Fig. 10.1.1 Mode switch
Fig. 10.1.2 4 button keypad, 2 digit display
2
2 digit display
5
4 button keypad
> 3s Reset
< 3s Quit
> 3s
PRG
< 3s
LEARN
Fact-Setup
> 3s
> 8s
2
5
Close
2.. Use 4 button keypad as outlined in Steps 1 through 8
to view or change parameter values.
Parameter
Description
1
AS
Installation type
2
rd
Reveal depth
3
Tb
Door width
4
dL
Door type
10.2.1 Configuration parameters.
Configuration parameters (Table 9.2.1) are set during
operator initial setup. Reference Chapter 10.
Table 10.2.1 Configuration parameters
10.2 Configuration parameters
10.3 Driving parameters
10.1 ED50/ED100/ED250 OHC – viewing and changing parameters