36
ED50/ED100/ED250
09-2021
DL4617-003
dormakaba ED50/ED100/ED250 OHC Header
Setup and Troubleshooting Instructions
Chapter 12
Fig. 12.5.4 Door bottom pivot on floor pivot bearing
1
Floor pivot
1.1
Height adjustment
2
Door bottom pivot
3
Door
1
2
4
3
5
6
1.1
4
Jamb
5
Door bottom pivot
mortise
6
Bearing
12.5.1 Hang door. RH inswing example.
TIPS AND RECOMMENDATIONS
A second person is recommended for door
installation!
WARNING
Hand pinch point and crushing hazards during
door install.
WARNING
Crushing hazards during door install.
12.5.2 Move door under overhead arm.
1. Hold door vertical and parallel to overhead arm.
2. Move door under overhead arm (Fig. 12.5.2).
12.5.3 Slide door onto bottom pivot.
1. Slide bottom door pivot release lever over bottom
pivot (Fig. 12.5.1) until door lowers onto bottom pivot
bearing (Fig. 12.5.4).
• Bottom door pivot release lever holds door bottom
pivot in place over bearing.
2. Overhead arm mounting holes should be aligned
with hex bolt clearance holes in overhead arm
mortise (Fig. 12.5.3).
12.5 Hang door
1
1.1
2
3
4
4.1
Fig. 12.5.1 Door positioned for installation
Fig. 12.5.2 Slide door onto bottom pivot
1
Floor pivot
1.1
Bearing
2
Door bottom pivot
3
Overhead arm
4
Overhead arm
door mortise
4.1
Clearance holes for
1/4 x 1" SHCS
Fig. 12.5.3 Overhead arm in door mortise
Slide door into
position
