Exit Device Operators 630/750/79E/RT/E7900 Series/ Generation E-730 PK3677_T
10-18
11
CAUTION
WARNING
IMPORTANT
If the lock will not respond to any keycard (includ-
ing the Emergency keycard), there are four options
that should be attempted to open the door. In
order, they are:
1. Verify the batteries, and replace them if they
are providing less than 4 Volts total. Use the
Emergency keycard.
2. Use the electronic override feature (requires
FDU and communication cable or ATLAS
M-Unit and IPM).
3. Use mechanical key if locking system has one
(see Section J, step 8).
4. Contact Technical Support for instructions on
using the drill point.
Electronic override using the FDU:
(For electronic override using ATLAS, please refer
to ATLAS user guide)
If the card reader fails, the E-730/630/750/79E
lock can be opened using the FDU (Front Desk
Unit). The lock must have been initialized by a
valid FDU from the hotel where it is installed (i.e.
with the correct internal and external hotel codes),
before the electronic override can be used.
There are two possible security levels:
Low security: IF an FDU with a software version
lower than V2.01 overrides the lock, the lock audit
records only the date and time.
High security: IF an FDU with version V2.01 or
higher software overrides the lock, the lock audit
records the FDU number, the Authorization key-
card number, the date and the time.
Hardware Required:
Front Desk Unit (FDU) and Communication Cable
Minimum Authorization Keycard Required:
Programming Authorization (PA)
G Operating the emergency override
For RT lock series,
please refer to system 6000 manual. For multihousing refer to RezShield manual.
S
teps to activate the E-730/630/750/79E
electronic override:
1. Insert the communication cable into the lock.
Wait 2 seconds, then connect the cable to the
serial port of the FDU.
CAUTION
WARNING
IMPORTANT
Some messages on the screen may differ depend-
ing on the FDU version, but the menu choices are
the same.
2. Press any key to activate the FDU, then swipe
a PA or higher keycard through the FDU. If the
green LED on the lock flashes once, disconnect
the cable from the Serial Port, wait 2 seconds,
and reconnect the cable.
Main Menu:
1 = Keycard
2 = Reset
?
3. Enter 8 to select the Programming Menu, then
press < >.
Program
1 = A lock
2 = Another FDU
?
4. Wait 2 seconds. Enter 1 to select the Lock
option, and press < >.
Enter Function
1 = Program Addresses
2 = Reset Addresses
?
5. Enter 7 to select the Override option, then
press < >.
Ready to perform anelectrical
override.
Strike a key, or C to quit
6. Wait 2 seconds, then press any key on the FDU
to activate the electronic override. The green
LED on the lock should light. The following mes-
sage should appear on the FDU screen immedi-
ately or within 2 seconds.
Trying to establish
communication
