(P/N) 3118.0210 Rev C 06/18 • © copyright 2010-2018
dormakaba USA Inc.
Page 1 of 4
INSTALLATION INSTRUCTIONS
The installation instructions are the basis for Security Agency Approvals. The lock installation must be done in accordance to
these instructions in order to maintain the labeled approval level.
In order to maintain VdS Class 2/EN 1300 Class B lock approval levels in a container where multiple locks are required, special
considerations must be observed. The Auditcon 2 Series lock must be the first one secured by the boltworks. Check the locked
status of the container with the handle of the boltworks.
Design Parameters for Auditcon 2 Series Locks
1. Bolt dimensions (nominal): .313 inches x .900 inches/7.95 x 22.8mm
2. Bolt movement (nominal): .475 inches/12.07mm
3. Bolt extension: .475 inches/12.07mm
4. Maximum load movable by the bolt: None
NOTE:
Auditcon 2 swing bolt locks must be installed in such a way that no side or counter acting load affects the bolt and the
bolt can move freely.
5. Maximum load against bolt when thrown (all directions): 224.8 lbs.(1kN)
6. The lock can be fitted to safes or vault doors of any material.
NOTE:
As is the case with all mechanical and electronic locking devices, the container and boltworks must be designed to
protect the lock.
AUDITCON
®
2 SERIES LOCKS
MODELS 52, T52, 252, 552 - ROUND HOUSING SWING BOLT
Basic Tools and Materials Needed
• Medium Phillips head screwdriver (#2) (recommend
magnetized tip)
• 6/64" Allen Wrench
• ESD wrist band
Recommended, but not required:
• Torque screwdriver (30 inch-pounds/3.4 newton-meters
capacity)
• Loctite
®
262 (Red) for use on lock case mounting screws
WARNING: dormakaba
locks are protected from 25,000
V Electrostatic Discharge (ESD) damage when correctly
installed. Follow these precautions to avoid ESD damage
when installing the lock:
• Handle the keypad assembly by the outer edge only.
• Use an ESD wrist band grounded to the lock or container
during installation.
Dial Assembly
Lock Case
Assembly
Dial Assembly
Mounting
Screws (2)
Lock Case
Mounting
Screws (3)
Keypad Assembly
with Decal
Cable
Figure 1 - Swing Bolt Lock Parts
Figure 2 - Swing Bolt Clearances and Positioning
