Operation
Technical Manual
111
V28 - 08/2019
Electronic safe lock
5.
Press the ENTER key to confirm the code.
6.
If an opening code with Time Delay was defined, the window for Opening Time Delay ap-
pears and the timer starts counting the set Time Delay.
ð
The remaining time will be displayed.
ð
Every 60 seconds a beep signal sounds while the Time Delay is counted.
If the timer has elapsed, another beep signal indicates the end of the Opening Time
Delay.
7.
After the Opening Time Delay has elapsed, the Confirmation Window appears.
The timer starts counting the set confirmation time.
The remaining time for lock opening must be confirmed.
8. Enter the opening code.
9.
Press the ENTER key to confirm the code.
10. If the input unit is set to Dual Mode, a second code must be entered.
11. Press the ENTER key to confirm the code.
ð
The lock opens.
12. Open the safe.
ð
If desired, continue in Programming Mode.
16.3.2
Opening procedure in ICS Mode
If no key has been pressed for 1 minute, the display switches off automatically.
1.
If necessary, press any key to wake up the display.
ð
The lock status appears.
2.
Enter a 4-digit ID, for example 3512 by using the NUMERC keys.
ð
For every entered digit an asterisk appears.
