Installation Instructions for Wi-Q™ Technology 45HQ Mortise Locks
BEST
a Product Group of
dormakaba USA Inc.
5
Installation Instructions for Wi-Q™ Technology 45HQ Mortise Locks
Installing the trim
9
Install concealed cylinder & core
1 Use a cylinder wrench to thread the cylinder into
the mortise case so that the groove around the cyl-
inder is even with the door surface as shown in Fig-
ure 8.
Caution:
A malfunction can occur if the cylinder
is threaded in too far.
2 Secure the cylinder in the mortise case with the cyl-
inder retainer screw.
3 Insert the control key into the core and rotate the
key 15 degrees to the right.
4 With the control key in the core, insert the core into
the cylinder.
5 Rotate the control key 15 degrees to the left and
withdraw the key.
Caution:
The control key can be used to remove
cores and to access doors. Provide adequate
security for the control key.
10
Install trim hole insert and bushing
1 Insert the trim hole insert into the upper trim hole
on the outside of the door, as shown in Figure 9.
2 Insert the bushing into the harness hole on the out-
side of the door, as shown in Figure 9.
Figure 8
Installing the concealed cylinder
Cylinder
retainer
screw
Outside of door
Figure 9
Installing the trim hole insert and bushing
Trim hole insert
Bushing
