Installation Instructions for Wi-Q™ Technology 45HQ Mortise Locks
BEST
a Product Group of dormakaba USA Inc.
9
Installation Instructions for Wi-Q™ Technology 45HQ Mortise Locks
Completing the installation
15
Install battery holder
1 Position the battery wires against the fire plate
side wall, as shown in Figure 14.
2 Slide the battery holder behind the fire plate
side tabs until it rests on the bent battery holding
tabs.
Caution:
When routing the battery wires, make
sure the wires are not routed across any sharp
edges or over any surface that could damage
their sleeving or wire insulation.
3 Connect the battery pack to the battery connector
on the wire harness.
Caution:
When connecting the battery pack,
make sure:
16
◆
there are no loose wire connections where the
wires are inserted into the connectors.
◆
the connectors are firmly mated.
Install inside and outside levers
1 Unscrew the inside spindle one full turn to allow the
spindles to turn freely.
2 With the handle pointing toward the door hinges,
insert the outside lever and spindles assembly into
the lock from the outside of the door.
3 Slide the inside lever onto the inside spindle and
secure it with the set screw.
4 Making sure that the core is positioned properly in
the outside escutcheon (DV and TV function Locks
only) and the escutcheons are aligned properly on
the door, tighten the escutcheon mounting screws.
Note:
If a core is not available, you can use the cylin-
der wrench to help you align the core opening in the
escutcheon.
5 Turn the levers to check that they operate
smoothly.
Inside of door
Figure 14 Installing the battery holder
Battery holder
Battery wires
Battery
wires
Battery holding
tabs
Antenna
wire
Figure 15 Installing the levers
Location
of set
screw
Inside of door
Spindles
Spindles
Outside of
Outside of door
