33
To get the Sign on Key number:
In the Wi-Q Interface Software, at the top of the screen, note the Segment Sign On Key
number.
Figure 11 Locating the Segment Sign On Key.
At the Controllers
Once you have the sign on key number, you can return to the site and prepare to sign on all
controllers.
Signing on Keypad Controllers
If your segment uses keypad controllers, use the following steps, in sequence, to register
each controller in the system. Once this is done, the controllers will appear in the Wi-Q
Interface Hardware Segment tree and Controllers tab.
Note
The following sequence is timed. Be sure to have your segment sign on key ready to enter
at the appropriate time.
1 Have your six-digit segment sign on key number ready.
2 At a keypad controller, press the following number sequence on the keypad: 5678#
(Wireless Door Controller) or 5678 (WAC). The green light will flash three times.
3 Within five or six seconds, begin to enter the six-digit segment sign on key number,
followed by #. You will have about five seconds to enter each number. The sequence will
time out if more than five seconds elapses between numbers.
Sign on key
Summary of Contents for BEST Wi-Q ONGUARD
