58
Crane 4000LE
07-2022
RL6002-003
Chapter 16
Crane 4000LE Wiring, Setup and Troubleshooting Manual
In-ground Motion Assist 360 drive and speed control
Remote control enclosure
16 Error list
16.2.1 Reset column of error list.
Indicates whether an error message:
• Is reset automatically (A).
• Must be reset with the program switch (M).
16.2.2 Error acknowledgment using the program
switch.
1. Check error number on controller display and correct
it according to the error list.
2. Ensure no one is in revolving door.
3. Set the program switch to "0" — Off.
4. After a minimum 3 second waiting time, restart the
revolving door using the program switch.
5. If necessary, perform steps outlined in Behavior after
reset column (learning cycle or commissioning of
sensors).
16.2 Reset column of error list (Para. 16.3)
16.1 Error
indication
16.1.1 Display of error number.
• Errors occurring during the learning cycle or
commissioning of sensors are shown on the control
unit display with an error number.
• The error list (Para. 16.3) contains information
regarding each error number.
WARNING
Risk of injury due to improper error correction!
Injuries and property damage may result if
malfunctions are not properly corrected.
• Have a dormakaba technician correct all
errors!
WARNING
Risk of injury when eliminating fault with
unknown error message!
Unauthorized fault elimination of an error
message not described may result in serious
injuries.
• If error message is not in Error list
(Para. 16.3) always contact dormakaba for
error correction.
• Never attempt to eliminate an unknown
error without assistance from dormakaba
service!
WARNING
Life-threatening danger due to inactive safety
equipment!
During the learning cycle, the safety equipment
required for normal operation is not yet
operational. Persons present in the revolving
door during the learning cycle may sustain
injuries.
• Insure that no one is present in the area of
the door wings.
• Start the learning cycle only after everyone
has left the area.
16.1.2 Error code indication with fault LED.
Error numbers are indicated with combinations of slow
and fast flashing codes.
• The first digit of the error number indicates how
frequently the fault LED flashes slowly
(approximately 1 Hz).
• The second digit of the error number indicates how
frequently the fault LED flashes rapidly
(approximately 2 Hz).
• Example: LED flashes 1 x slow and 4 x fast.
Error number 14 (braking distance at safety stop too
long).
Fig. 16.1.1
Fault LED
Ø0.23 [5.8 mm]
lens diameter
Ø0.33 [8.3 mm]
flange diameter
