88
Crane 4000LE
07-2022
RL6002-001
Crane 4000LE Installation Manual
In-ground Motion Assist 360 drive and speed control
Remote control enclosure
Chapter 21
21 Install floor strikes
21.1 Install
floor
strikes
21.1.1 Home position.
1. Rotate wings to home position.
21.1.2 Mark floor strike hole locations.
1. Move wing lock handle down until wing lock pin
contacts floor surface.
2. Mark circumference of pin on floor.
• Wing lock pin diameter: 5/8"
3. Raise wing lock handle.
4. Mark centerpoint of wing lock pin on floor.
5. Repeat steps 1 through 4 for second wing lock.
21.1.3 Drill floor strike holes in floor.
1. For concrete floors, drill 1 inch diameter hole in floor
to a depth of 2".
• Use hammer drill with masonry bit.
CAUTION
Drill must be perpendicular to floor.
2. Repeat step 1 for second floor strike.
21.1.4 Clean any dirt and debris from floor strike holes.
CAUTION
Insure floor strike holes are clear of dirt and
debris.
1. Use a vacuum or blower to remove any debris inside
each hole.
21.1.5
Install floor strikes.
1. Fill hole with grout.
• Use a grout such as QUIKRETE® FastSet™ non-shrink
grout.
2. Place floor strike in hole.
3. Tap floor strike into place using wood block or other
material to prevent surface damage to strike.
4. Clean excess grout from floor area around strike.
CAUTION
Note manufacturer's cure time for grout
before walking on strikes or using wing locks.
5. Repeat steps 1 through 4 for second floor strike.
Fig. 21.1.1
Floor strike RC6265-0X0
Fig. 21.1.2 4 wing door, wing locks
Fig. 21.1.3 Floor strike installed
1
1
2
2
2
Part / Assembly
Description
1
Wing lock
2
RC6265-0X0
Floor strike
Table 21.1.1
Wing locks and floor strikes
